[ Chinese wardrobe net ] Anyone who knows about custom wardrobes knows that wardrobes still have "standard" and "non-standard" points. However, many consumers do not understand that since it is a custom closet, of course, it must be done in full accordance with the requirements of customers. Why should it be divided into "standard custom" and "non-standard custom"? Sheet specification First of all, look at the panels made of wardrobes. In the custom wardrobe industry, 1220*2440mm gauge plates are commonly used, and the width of the panels is limited. How to open the material to maximize the utilization of the board, reduce the production cost of the product, and finally make the wardrobe not too high. Now let's analyze how the manufacturer improves the utilization of the board. The cabinet has 300mm, 400mm, 500mm, 550mm standards. 20mm in the 1220mm board is 2cm. Because the board will be bumped during the transportation process, the corners of the board will collapse. Therefore, the 2cm furniture manufacturer will cut 1cm from side to side for the trimming. Therefore, the remaining 1200mm plate can be sawed 4 pieces of 300mm, 3 pieces of 400mm, 2 pieces of 500mm, and what is the remaining 20mm? Saw into 2 pieces of 10mm to make the sliding door track pad or baseboard. Two pieces of 550mm, the remaining 10mm is still used as a sliding door track pad or baseboard. Finally, take a 1200mm board saw and two 600mm to make the outer side of the closet. The above method of cutting is the most material and also the best factory process management. There is no pile of material left in the factory floor. Standardized scale factory For custom wardrobes in "non-standard" and "standard", this is a problem with the production of large-scale, standardized brands. For some small workshop-style wardrobe manufacturers, there are not many stores in the country, or even one or two local stores. There aren't many orders in a month, and the production workshop does not have a standardized line like the scale of brand manufacturers. It is quite good to be able to receive a few orders, and he is still doing 600mm or 700mm. In a brand manufacturer, there are four or five hundred stores in the country and even more. The national orders are concentrated in a production line with a standardized production line. There are many raw material plates in the workshop, and the semi-finished products in the previous assembly line. If the saw plate is not the standard 600mm, but 700mm, the production workshop needs to stop and adjust many machines on the assembly line before production. On the other hand, the 1200mm board saw an 800mm, leaving 400mm. This 400mm can't be used for a while, it has to be piled aside, which puts a lot of pressure on the management of the production workshop. When can this board be used? What is the width? Can it be used? A lot of things are piled up, bringing unreasonable use of resources to a limited production floor. This is not like a small custom-made brand. When you need a wide plate, if the remaining materials have the same color and the same material, there is no stacking pressure in the workshop. If you need it, you can use a ruler to measure the width of the board. This is why there is a “non-standard†problem for large brands with standardized production lines. Ningbo XISXI E-commerce Co., Ltd , https://www.xisxipet.com