In the home decoration, a lot of decoration plates are needed. At present, the quality of various plates on the market is mixed. The top ten brands of Shenzhou are reminding consumers that when choosing, they must make scientific choices. Pay special attention to the following points: First, recognize the difference between artificial veneer veneer and natural wood veneer veneer: the texture of the former is basically straight texture, the texture pattern has rules; while the latter is natural wood pattern, the texture pattern is natural, the variability is relatively large, and there is no rule. .
Desk controller basic software is a PC/MAC software reminding the user to use the office desk. Allows user to control height adjustment and pre-set individual optimal sit-stand table height. Pick your personal challenge for standing at your desk and improve your health and work habits over time.
Hand controller also has many functions, such as two memory controller, metric and inch switch, overheat / overload protection, anti colony feature, soft start / stop feature, child lock and so on. There are also many types of hand controllers to choose from to meet the different requirements of customers.
Desk Control,Office Desk Control,Standing Desk Control,Electric Desk Control,Desk Hand Remote Suzhou Uplift Intelligent Technology Co., Ltd , https://www.officestandingdesk.com
Second, observe the appearance of the board. The appearance of the board should have a good aesthetic, the material should be fine and uniform, and the color is clear. The wood grain is beautiful, the texture of the matching board and the parquet should be arranged according to a certain regularity, the wood color is similar, and the seam is almost parallel to the edge of the board.
Third, the surface should be no obvious defects. The surface of the material with good material should be smooth, free of burr groove marks and planing knife marks; there should be no penetration phenomenon and surface contamination (such as local yellowing and blackening); the surface should be selected as follows without cracks, cracks, no knots, The skin, the resin capsule and the gum road; the natural warpage of the whole board should be as small as possible to avoid the sand penetration phenomenon caused by the improper operation of the sanding process and the substrate.
Fourth, the rubber layer structure is stable, no open glue phenomenon. It should be noted that there should be no bulging or delamination between the surface veneer and the substrate and between the layers inside the substrate.
Fifth, choose a plate with low formaldehyde emission. Decorative panels with a pungent odor should be avoided. Because the greater the odor, the higher the amount of formaldehyde released, the more harmful the pollution, the greater the harm.
6. Choose products with a clear production enterprise. Products with a clear factory name, site and trademark should be selected.
Seven, for the three-dimensional veneer, the inferior board with the nails gently on the board surface, it will leave a clear impression, high-quality veneer will not have these problems. 
