Three principles of mechanical watches routine maintenance of a note

For a long time standing, the mechanical watch's spring relax naturally to the watch stationary, then, to wear again, you must first re-tighten the clockwork, and then calibrate the time. General mechanical watch in the most loose clockwork, there will be hour hand, minute hand to slow down or become faster, so you should tighten the clock, to avoid the calibration time, there is no standard power-driven pointer, even the automatic winding watch , Should also be manually winding up to eight full, then time calibration.

Mechanical watches self-cleaning, maintenance of the principle

Those who engaged in water sports watches, we need to do "maintenance", especially after soaking sea salt, filtering chemicals water quality in the swimming pool, are likely to cause watch waterproof gasket erosion, hardening; some maintenance can do their own home and simple with a soft cloth with a small amount of soapy water to clean metal and waterproof rubber strap, and finally wipe with a damp cloth to remove soap and water after traces dried, can be reached preliminary performance of maintenance, while, do not send directly to the table To have a place to do ultrasonic cleaning equipment, because there are strong points of ultrasonic cleaning, weak different frequencies, but the use of wrong ultrasonic frequency, it is easy to cause internal parts loose.

Table collection principle

Long time use or long timekeeping watches, watches must pay special attention to the maintenance period, the general maintenance of mechanical watches paragraph about 3 to 4 years, once over this period, the case internal grease easily dry, external waterproof gasket is easy to harden, reluctant to use mechanical parts prone to failure and water stains and dry lubricants cause problems with wear and tear parts, the initial impact is not caused by the operation, only to see the accuracy of time getting lower and lower over time, when the stop In operation, the loss of internal parts has been very serious, to such a point, "minor" maintenance costs become "large" parts maintenance costs.

In addition to mechanical repairs and maintenance to avoid problems, quartz watch in addition to the problem of internal parts lubricated with water driven in a long time not wearing the situation, if the battery has been used for a long period of time, it is best not on the table Shell to do long-term storage, in order to avoid battery failure, not only can not supply the problem, there may even be battery fluid leakage must be replaced by the internal parts of the problem.

Complex mechanical watches use the quick-dial button should pay attention to matters

When the time is not precise enough, the complex performance of the mechanical watch adjustment, there are some ways to be followed Each mechanical performance of a mechanical watch is sold will be accompanied by operating instructions, even the shared movement watch, but also because the table Plant modification, the emergence of different parts configuration, the operation must pay special attention to the order, so read the operating instructions is the first priority.

If you really bother, you need to pay special attention to the correct use of fast-dial button, when you start the dial-up performance, the clock must be adjusted to the correct position, it will not cause performance parts have been stuck into the correct position, was forced to beat The problem caused by part spin-up caused by turning the quick-release button.

Fast dial button in addition to operating the operating instructions, the vast majority of watches should be avoided at night from eight o'clock to four o'clock in the morning, but also the most troublesome consumers, because there are almost all air conditioning time Is the evening; at this time, you can take the strain of the way, is the clock back to five o'clock to seven o'clock position, the watch has been prepared to move the next gear stuck loose, at this time and then fast dial adjustment will not There are problems, but some brands of watch gear set to perform the conversion action at noon, if it was noon then no problem directly adjust the fast-forward button will lead to parts malfunction, so, the clock on the five o'clock to seven o'clock The location most suitable for most of the watches.