After the copying machine reaches a certain number of copies, or when the quality of the copy is significantly reduced, maintenance is required. Only timely repair and maintenance will not damage the machine, and it can always maintain a satisfactory copying effect. The use of copiers Everyone must also pay attention to the daily use of correct methods is particularly important. 1. Select the right place to install the copy, pay attention to high temperature, dust, shock, direct sunlight, and ensure a good ventilation and ventilation environment, because the copy opportunity to produce trace amounts of ozone, and the operator should be every work for a period of time to Breathable outdoors for a short break. Usually try to minimize the move, if you want to move, be sure to move horizontally. Do not tilt. To ensure optimum operation, leave at least 90 centimeters on the left and right sides of the machine and 13 centimeters on the back (if the machine is equipped with a sorter, a distance of about 23 centimeters is required.) Care must be taken to operate and use the copier. 2, should use a stable AC connection, the power rating should be: 220-240V, 50Hz, 15A. 3, after work every morning, to open the copier preheated warm about half an hour, so that the copier is kept dry. 4, to keep the copier glass platen clean, no scratches, can not have correction fluid, fingerprints and other types of spots, otherwise it will affect the copy effect. If spotted, use a soft glass cleaner to clean the glass. 5, in the work of the copier must be covered in the upper block, in order to reduce the strong light on the eyes of the stimulus. 6, if you need to copy books and other documents that need to be bound, please use a copy machine with "split scan" performance. In this way, copy shadows due to unsmoothing of the binding can be eliminated. 7. If the background of your copy is shaded, dust may have entered the lens of your copier. At this point, you need to professionally clean the copier. 8, when the copy machine surface display red light plus powder signal, the user should promptly add toner to the copier, if the powder is not added in time can cause the copier to malfunction or produce powder impact noise. When adding toner, shake the toner and follow the instructions. Do not use substitute powder (pseudo-powder), otherwise it will cause problems such as flying powder, bottom ash, and shortening the service life of the carrier. Moreover, due to the high rate of waste powder it produces, the actual copy quantity is less than 2/3 of the true powder. . 9. Before adding copy paper, check whether the paper is dry and clean. Then, straighten the copy paper and stack it neatly and place it in the paper tray with the same size and size. The paper in the tray cannot exceed the thickness allowed by the copier. Please consult the manual to determine the thickness range. In order to keep the paper dry, a box of desiccant can be placed in the copying machine tray. After using copy paper each day, the copy paper should be wrapped and placed in a dry cabinet. 10. After using the photocopier each time, be sure to wash your hands in time to eliminate the harmful effects of residual dust on the human body. 11. Turn off the power switch of the copier when the work is off and cut off the power. Do not pull the power plug without turning off the machine switch. This can easily cause a malfunction of the machine. 12. If the following conditions occur, turn off the power immediately and ask for service personnel. A, abnormal sound in the machine; B, the machine shell becomes overheated; C, the machine part is damaged; D, the machine is rain or water inside the machine. Horse Wrap And Boots ,Horse Leg Wraps,Horse Ankle Boots,Horse Boots For Jumping NINGBO BRIGHT MAX CO., LTD. , https://www.smartrider-horsecare.com